Wire take-off unit: Take-off speed 1 ...25 m/min
Intended use
The unit takes off the coated wire and winds it up.
Wire take-off unit
- With water bath
- With CAN bus
You have a specific type of problem or need a special configuration?
The unit takes off the coated wire and winds it up.
You have a specific type of problem or need a special configuration?
The wire take-off and winding unit takes off the coated wire and winds it up. The blank wire is straightened before it is coated in the wire coating die.
After cooling in the water bath, the two nip rolls take off the wire at a constant tension. The coated wire is then wound up evenly via a traversing device on a winding roll.
The wire take-off unit can be controlled manually or through the PC (via CAN bus).
Nip rolls | 84 mm Ø, 228 mm long high-polished steel, chrome plated |
Pressure roll | 84 mm Ø, 228 mm long rubberized |
Winding roll with slip clutch | 84 mm Ø, 212 mm long |
Drive | inverter drive, 0.37 kW take-off speed: 1...25 m/min |
Dimensions (H * W * D) | 1750 * 870 * 750 mm |
Mains | 230 V, 50...60 Hz |